Dell PowerConnect 8024 Guia De Inicio Rapido página 214

Unit 1 - Waiting to select management unit)>
Applying configuration, please wait...
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch configuration,
and gets you up and running as quickly as possible. You can skip the
setup wizard, and enter CLI mode to manually configure the switch. You
must respond to the next question to run the setup wizard within 60
seconds, otherwise the system will continue with normal operation using
the default system configuration.Note: You can exit the setup wizard
at any point by entering [ctrl+z].
Would you like to run the setup wizard (you must answer this question
within 60 seconds)? [Y/N] y
The system is not setup for SNMP management by default. To manage the
switch using SNMP (required for Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and setup other SNMP accounts. (For more information
on setting up an SNMP version 1 or 3 account, see the user
documentation).
Would you like to setup the SNMP management interface now? [Y/N] y
To setup the SNMP management account you must specify the management
system IP address and the "community string" or password that the
particular management system uses to access the switch. The wizard
automatically assigns the highest access level [Privilege Level 15]
to this account. You can use Dell Network Manager or other management
interfaces to change this setting and to add additional management
systems later. For more information on adding management systems, see
the User's Guide .
To add a management station :
Please enter the SNMP community string to be used [public]:public
| ‫מדריך תחילת עבודה‬
217
‫הבאה‬ ‫שיח‬ ‫הדו‬ ‫תיבת‬
: -
‫מופיעה‬ ‫המתג‬ ‫ואתחול‬
,
‫בדיקת‬ ‫השלמת‬
POST
‫שלב‬
:1
‫לאחר‬