Optional Installation; External Battery Connection - Tripp-Lite SmartPro SMART750XLA El Manual Del Propietario

Optional Installation

These connections are optional. Your UPS will function properly without these connections.
1
USB and RS-232 Serial
Communications
Use the included USB cable
cable 1b to connect the communication port on
your computer to the communication port of your
UPS. Install on your computer the Tripp Lite
PowerAlert Software appropriate for your
computer's operating system. Consult the
PowerAlert manual for more information.
2
Telephone/Network Protection Jacks
Your UPS has jacks that protect against surges
over a telephone line or a network data line. Using
telephone or network data cables, connect your
wall jack to the UPS jack marked "IN." Connect
your equipment to the UPS jack marked "OUT."
Make sure the equipment you connect to the UPS
jacks is also protected against surges on the AC
line.
3

External Battery Connection

Your UPS comes with a robust internal battery
system; external batteries are needed only to
extend runtime. Adding external batteries will
increase recharge time as well as runtime.
The illustration shows the location of the External
Battery Connector
battery pack cable. Complete installation
instructions for your battery pack appear in the
battery pack owner's manual. Make sure that
cables are fully inserted into their connectors.
Small sparks may result during battery connection;
this is normal.
Warning: Do not connect or disconnect
battery packs when the UPS is running on
battery power.
14-12-047-932773.indb 4
1a and/or DB9 serial
A , where you will insert the
4
1a
1b
2
3
A
12/17/2014 4:31:26 PM