KALLISTA P72025 Guia De Instalacion página 4

Setting Tool
Anchor
Marble
Foam Padding
Anchor Screw
2. Install the Undercounter Lavatory
Cut out the opening by carefully following the pencil line traced
from the template.
NOTE: The screws and anchors provided should be used on
countertops with a minimum 1" (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and fasteners (not provided).
Do not use the anchors provided when installing the lavatory to a
countertop or console table where anchors are already present.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
Install the faucet and drain according to the manufacturer's
instructions.
NOTE: Only use silicone sealant. Kallista recommends using a
quality color-matched silicone sealant. Do not use adhesives or
adhesive sealants.
116108-2-D
Clamp
Apply sealant.
4 Kallista