Dash Disassembly - Metra 99-7882B Manual De Instrucciones

1. Open the pocket door below the
radio, remove (2) Phillips screws
exposed, and then remove the
pocket. (Figure A)
2. Remove (2) Phillips screws from the
bottom edge of the radio. (Figure B)
3. Remove (2) 8mm screws facing
up from inside the pocket cavity.
(Figure C)
4. Unsnap and remove the climate/
radio panel assembly. (Figure D)
5. Remove the components from the
climate/radio panel to be reused in
kit assembly. (Figure E)
a. Remove (4) screws from the
climate control panel.
b. Remove (2) screws from the
factory hazard button.
c. Remove (3) screws from the
factory vent.
d. Remove (3) screws from the
lower trim panel.
Continue to kit preparation

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
®
99-7882B
Step 5 c
Step 5 b
Step 5 a
(Figure E)
2
(Figure D)
Step 5 d