Kit Preparation
1.
Secure the factory components removed in dash disassembly to the radio panel. Except for the
(3) screws to secure the lower trim panel, either the factory screws or the (9) #8 x 3/8" Phillips
pan-head screws supplied with the kit may be used. For the lower trim panel use the (3)
#4 x 3/8" Phillips truss-head screws supplied with the kit to secure it to the panel. (Figure A)
2. Attach the (3) metal and (3) plastic panel clips to the radio panel. The factory metal
clips may be used in place of the metal clips, but not the plastic clips. (Figure A)
Continue to kit assembly
Metal clip locations
Plastic clip
locations
(Figure A)
®
99-7882B
ISO DIN radio provision with pocket
1. Secure the pocket to the radio brackets
with the (4) #8 x 3/8" Phillips pan-head
screws supplied with the kit. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio between the bracket/
pocket assembly and secure it with the
screws supplied with the radio. (Figure B)
4. Secure the completed assembly to
the radio trim panel with the (4) #8
X 3/8" Phillips truss-head screws
supplied with the kit. (Figure C)
5. Locate the factory wiring harness and
Plastic clip
antenna connector in the dash and
location
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Re-connect the
negative battery terminal and test the
radio for proper operation.
6. Reassemble the dash in reverse order
of disassembly using the (2) #8 x 1/2"
Phillips pan-head screws supplied
with the kit for the lower radio mounts.
3
Kit Assembly
(Figure A)
(Figure B)