Dell PowerConnect 7000 Serie Guia De Inicio Rapido página 397

You must respond to the next question to run the setup
wizard within 60 seconds, otherwise the system will
continue with normal operation using the default
system configuration. Note: You can exit the setup
wizard at any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not setup for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and setup other SNMP accounts. (For
more information on setting up an SNMP version 1 or
3 account, see the user documentation).
Would you like to setup the SNMP management interface
now? [Y/N] y
To setup the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to
change this setting, and to add additional management
system information later. For more information on
adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used.
[public]: public
NOTA:
Se estiver configurado, o nível de acesso padrão é definido como o nível de
acesso disponível mais abrangente para a interface de gerenciamento SNMP. A
princípio, somente o SNMPv2 será ativado. O SNMPv3 estará desativado até que
se volte a configurar o acesso de segurança para SNMPv3 (por exemplo, ID do
mecanismo, visualizar, etc.).
Guia de Primeiros Passos
395