If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
Problem
No sound
No reaction to any operation
of the keys
CD PLAYER
CD playback does not work
RADIO
Occasional crackling sound
during FM broadcast
Continuous crackling/
hiss disturbance
during MW/ LW broadcast
ALARM
The alarm does not function
The Weekend-Sleeper does
not function
This product complies with the radio interference requirements of the European Union.
Possible cause
Volume not adjusted
Electrostatic discharge
CD badly scratched or dirty
Laser lens steamed up
Laser lens dirty
CD-R(W) is non-finalized
Weak signal
Electrical interference from TV's,
computers, fluorescent lamps, etc.
Alarm time not set
Alarm mode not selected
Volume too low for radio/ CD/
buzzer alarm mode
Day selection not set/ incorrect
Weekend-Sleeper not set
The type plate is located on the bottom of the set.
TROUBLESHOOTING
Remedy
Adjust the VOLUME
Disconnect the set from the mains
supply and reconnect the set after
5 minutes.
Replace/ clean CD
Wait until lens has acclimatized
Clean lens by playing a CD lens
cleaning disc
Use a finalized CD-R(W)
Extend pigtail fully
Move set away from other
electrical equipment
Set alarm time
See chapter on Setting ALARM 1
or ALARM 2 time
See chapter on
Gentle wake volume
See chapter on SETTING THE DAY
Set Weekend-Sleeper
13