Firmware Upgrade - Philips Nike psa[cd8 Manual Del Producto

firmware upgrade
occasionally, philips releases new software ("firmware") for your set.
1
connect the mains adapter to DC on the set and to the wall socket (see "mains
adapter").
2
keep mode pressed for 3 seconds.
the type of your set and the current version of the firmware are displayed. Upgrade?
is displayed.
press 9 .
3
4
visit homepage http://www.nike-philips.com. check if there is a firmware file for your
set and if the firmware version is higher than the current version of your set.
download the file and burn it on a cd-rom.
5
insert the cd-rom into the set and keep mode pressed for 3 seconds.
Upgrade? is displayed.
press 2; .
6
upgrading is displayed and upgrading starts. this may take some minutes. after
upgrading is finished, Upgrade complete is scrolled.
Wrong upgrade file is scrolled: your set already has the latest firmware or the
downloaded file does not correspond to your set.
Ugrade file defect is scrolled: the upgrade file has been damaged during the
download or when burning the cd-rom. download the file again, burn a new cd-rom
and try again.
No upgrade file is scrolled: no upgrade file was found on the inserted cd-rom.
note: if upgrading is interrupted accidentally, repeat step 6 until upgrading
is completed successfully.
general information
9