Technical Data; Declaration Of Conformity; Noise/Vibration Information - Bosch PSR 14,4 LI Manual Original

18 | English

Technical Data

Cordless Screwdriver
Article number
Rated voltage
No-load speed
Max. torque for hard/soft
screwdriving application
according to ISO 5393
Max. screw dia.
Max. drilling dia.
– Steel
– Wood
Chuck clamping range
Weight according to
EPTA-Procedure 01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
06.12.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
2 609 002 498 | (7.1.08)
PSR 14,4 LI
3 603 J54 1..
V= 14.4
0 – 450
rpm
Nm 28/12
mm
mm
mm
0 – 10
mm
kg 1.15
Dr. Eckerhard Strötgen
Head of Product
Certification

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is less than 70 dB(A). Uncertainty
K =3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
8
mined according to EN 60745:
Drilling into metal: Vibration emission value
2
a <2.5 m/s , Uncertainty K =1.5 m/s
10
h
Screwdriving: Vibration emission value
25
2
a <2.5 m/s , Uncertainty K =1.5 m/s
h
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Assembly
Battery Charging (see figure A)
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
2
,
2
.
Bosch Power Tools