Inglesina zippy Manual De Instrucciones página 27

Handwash in cold water.
Do not bleach.
Do not tumble dry.
Do not iron.
Do not dry clean.
LIST OF COMPONENTS
FRAME
fi g. 1
T1 Front wheel assembly
T2 Rear wheel assembly
T3 String blocking plug
T4 Armrest cover
T5 Handrail
T6 Handrail covering
T7 Feeding bottle holding unit
CARRYCOT / CAR SEAT
fi g. 21
C1 Zippy carrycot
C2 Huggy car seat
FRAME
ASSEMBLING THE REAR WHEELS
fi g. 2 Press the push-button A and hook the
rear wheels until hearing a CLICK signalling the oc-
curred hooking.
fi g. 3 Insert the strap B in the proper seat on
the frame.
fi g. 4 Insert the string blocking plug C.
CAUTION: the correct assembly of the joined
brake is important for the safe use of the frame.
fi g. 5 In case of problems when mounting the
plastic plug, it is possible to remove it as shown in
fi gure; then, repeat the procedure.
ASSEMBLING THE FRONT WHEEL ASSEMBLY
fi g. 6 Hook the front wheel assembly until
hearing a CLICK signalling the correct hooking.
CAUTION: make sure that the wheels are pro-
perly hooked before use.
fi g. 7 To remove the front wheel assembly,
WARNING!
Dry the textile lining completely before using or
storing it.
To prevent formation of mildew, it is advisable to
air the carrycot periodically. In detail, separate the
textile lining from the structure and run a dry cloth
over the bottom.
INSTRUCTIONS
press the spring D and extract the assembly simul-
taneously.
FRAME OPENING
fi g. 8
on the right handle, fi rmly lift the frame until it is
completely open.
fi g. 9
the pedal control F till the horizontal blocking po-
sition.
fi g. 10
are properly attached on both sides before use.
FRAME CLOSING
fi g. 11
the handle H.
fi g. 12
frame is completely closed.
fi g. 13
the central articulated joint.
TRANSPORTATION HANDLE
fi g. 14
proper handle I. Do not lift the frame by the ope-
ning handle H.
HANDLE ADJUSTMENT (FOR MODELS, WHERE
IT IS FORESEEN)
fi g. 15
handles in terms of height and direction; to adjust
the handle to the wished position, act on the inter-
nal push-buttons L.
REAR WHEELS BRAKE
fi g. 16
the lever M positioned on the rear wheels. Always
engage the brake during stops.
Keeping pressed the lever E positioned
Complete the procedure by acting on
Make sure that all closing mechanisms
By pressing the red push-button G, lift
Pull the handle fi rmly upwards until the
Make sure that the lever E is attached to
To transport the closed frame, use the
The frame is equipped with adjustable
To engage the brake, push downwards
27