Making Pasta - Silvercrest 600 A1 Instrucciones De Uso

4) If you are making the porridge with milk, stir constantly while heating so that it
does not burn. If you are using water only, it is sufficient to stir the contents of
the pot occasionally.
5) Heat the contents of the pot for about 7 minutes and then switch off the appli-
ance. Allow the porridge to swell for approx. 5 minutes before serving.
Example porridge recipe
▯ 500 ml milk
▯ 150 g porridge oats (rolled)
▯ 3 tbsp. honey
▯ Strawberries, raspberries, blueberries (or berries of your choice)
▯ Almonds (according to taste)
▯ 1 lemon
1) Prepare the milk and oat flakes as described above.
2) Stir in the honey and allow the oat flakes to swell.
3) Toast the almonds in a pan (without fat) until they are fragrant.
4) Carefully wash the berries, pat them dry and clean. Quarter the strawberries.
5) Wash the lemon in hot water, pat dry and finely grate the zest.
6) Divide the porridge between 3 bowls and garnish with berries, almonds and
lemon zest.

Making pasta

1) Fill the pot
MAX (1.2 l) markings on the inside of the pot
than the MAX marking but at least to the MIN marking.
NOTE
► When filling the pot
other ingredients to the pot
food that will be added later, do not fill the water all the way up to the
MAX mark (1.2 l)! The total contents of the pot
exceed the MAX marking (1.2 l).
When cooking pasta, we recommend adding 1 litre of water and 100 g
of pasta to the pot
2) Close the lid
3) Press the rocker switch
4) As soon as the water is boiling, add a tsp. of salt and the pasta to the pot
and press the rocker switch
5) Stir the contents of the pot occasionally.
SET 600 A1
6
with water. When filling, pay attention to the MIN (0.5 l) and
6
with water, bear in mind that you will be adding
6
. Therefore, when cooking pasta or other
6
.
1.
5
to the left to position II.
5
to the right to position I.
6 6
. Fill the pot to no higher
6
(water + food) may not
GB │ IE
6
│ 9 ■