Fein WSG12-125 Instrucciones De Uso página 17

3 41 01 071 06 0.book Seite 17 Montag, 17. Oktober 2005 1:50 13
WSG 12-125 / WSG 12-150 / WSG 12-70 E
helps to protect the operator from broken
wheel fragments and accidental contact with the
wheel.
Clean the ventilation openings on the power tool at
regular intervals. The motor blower draws dust
into the housing. An excessive accumulation of
metallic dust can cause an electrical hazard.
Do not operate the power tool near flammable
materials. Sparks could ignite these materials.
Keep bystanders away from the working area.
Anyone entering the working area must wear per-
sonal protective clothing/equipment. Fragments
of the work piece or broken wheels can fly out
and also cause injuries to persons outside the
actual working area.
Conduct the mains lead away from the rotating
wheel. If you lose control over the power tool,
the mains lead could be cut through or caught,
thereby drawing your hand or your arm into the
rotating wheel.
Hold the power tool by the insulated gripping sur-
faces only, when performing an operation where
the accessory could contact hidden wiring or its
own cord. A cutting accessory contacting a live
wire may make exposed metal parts of the
power tool "live" and cause the operator an
electric shock.
Beware of any concealed electric cables, gas or
water conduits; check the working area with a
metal detector, for example, before commenc-
ing work.
Never lay the power tool down until the accessory
has come to a complete stop. The rotating acces-
sory could come into contact with the underly-
ing surface and cause you to lose control over
the power tool.
Do not carry the power tool at your side while the
motor is running. Accidental contact with the
rotating accessory could cause it to snag your
clothing, pulling the accessory into your body.
Causes of kick-back and precautionary
measures for the operator.
Kick-back is a sudden reaction of the power tool
to a pinched or snagged rotating wheel, backing
pad, brush or other accessory.
Pinching or snagging causes rapid stalling of the
rotating accessory, which in turn causes the
uncontrolled power tool to be forced in the
direction opposite to the accessory's rotation at
the point of the binding.
For example, if an abrasive wheel is snagged or
pinched by the workpiece, the edge of the wheel
entering into the pinch point can dig into the
surface of the material, causing the wheel to
climb out or kick out.
The wheel may either jump towards or away
from the operator, depending on the direction
of the wheel's rotation at the point of pinching
and can possibly also break.
Kickback is the result of power tool misuse and/
or incorrect operating procedures or conditions
and can be avoided by taking the proper precau-
tions listed below.
Hold the power tool firmly and position your body
and arms optimally to withstand any kickback
forces. Always use the original auxiliary handle so
that kickback forces or the starting torque can be
mastered in the best possible way. The operator
can master the starting torque and kickback
forces if suitable precautionary measures are
taken.
Never place your hand near the rotating acces-
sory. The accessory may kick back over your
hand.
Do not position your body in the area where the
power tool will move if kickback occurs. Kickback
will propel the power tool in the direction
opposite to the wheel's movement at the point
of snagging.
Take special care when machining corners, sharp
edges, etc. Prevent the accessory from bouncing
off or tilting. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory
and cause loss of control or kickback.
Do not attach a saw chain, wood-carving blade or
circular saw blade. Blades of this kind cause fre-
quent kickback or loss of control over the
power tool.
EN
17