Reversing The Door Opening Direction - Selecline HS-91FN Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Warning! It must be separated by a distance of at least
50
cm between sources of heat, such as cookers, ovens,
radiators and other stoves, and at least
ovens.
Warning! When you move the refrigerator, take care not
to roll it over the power cable or damage it.
1. Place the refrigerator in a well-ventilated area, on a dry, stable and flat surface,
away from direct sunlight and any other heat source.
2. Please leave room at the back of the appliance for air to flow. Do not place it
against a wall to avoid noise caused by vibrations. Make sure that air can
always flow freely around the appliance. Insufficient ventilation could cause the
appliance not to work properly and may increase energy consumption. Leave a
space of at least
least
30
cm between the top of the refrigerator and the ceiling.
3. If the refrigerator is placed on an unstable surface, you may adjust the balance
of the appliance by using the levelling foot (3). That will ensure proper operation
free from vibrations.
4. Turn the foot clockwise to raise the refrigerator. Turn the foot anti-clockwise to
lower the refrigerator ( fig. 1).
5. Be sure to leave enough space to be able to access and open the door easily
( fig. 12). If necessary, you can change the direction in which the door opens as
described below.

REVERSING THE DOOR OPENING DIRECTION

Warning! Unplug the appliance from the power socket
when you reverse the door opening direction.
Warning! During this process, keep all of the parts
together and out of the reach of children.
1. Fix the door in place with solid adhesive tape ( fig. 3).
2. Remove the top cover using a screwdriver ( fig. 4).
3. Carefully remove the top cover ( fig. 5).
4. Loosen the bolts on the top hinge using a socket wrench ( fig. 6).
5. Remove the levelling foot
( fig. 7).
6. Install the top and bottom hinges as well as the levelling foot on the opposite
side of the door using a socket wrench ( fig. 8, 9, 10).
7. Replace the top cover and secure it with screws removed previously ( fig. 11).
8. Remove the adhesive tape.
10
cm between the refrigerator and the wall, and a space of at
(7)
and the bottom hinge using a socket wrench
11
5
cm from electric

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

600081564

Tabla de contenido