Changing The Password (Pin); Ajdusting The Clock; Adjusting The Clock - Televes RSD - 7296 Instrucciones De Uso

User Manual User Manual
8.2.- Changing the Password
The password consists of 4 numbers, which will never appear onscreen.
Instead, some yellow icons appear and each time you enter a number, this
will change to green.
When you select any of the options in the Menú that imply theuse of the
secret code (access to blocked channels, changing the channel list, etc.)
the message "Enter Code" will appear onscreen, asking you to enter your
password.
If the password that is entered is incorrect, the message "Invalid code" will
appear onscreen, which denies access.
To change the current code, enter the current code using the numeric
buttons on the remote control in the field "Enter Old Code". The factory-
set default value is "0 0 0 0".
Enter the new password in the field "Enter New Code".
Confirm the new password by entering it again in the field "Confirm New
Code". If the two do not coincide, an error message will appear onscre-
en. If they do coincide however, the message "Password changed" will
appear.
From now on, you should always use the new code when this is required.

8.3.- Adjusting the clock

The receiver disposes of a Clock to indicate the time. This Clock adjusts
automatically to the information provided by the service supplier within the
actual satellite signal.
The service supplier sends two types of time information, one that is relativ
e to the current time (to be displayed by the Clock) and another that informs
the user of the time schedules of the different programmes (which is used
by the EPG).
Both types of information are sent in GMT format, so you must adjust the
Receiver by entering the time difference in your country.
By using the and
time as indicated in the "Hours" and " Minutes" options as regards GMT.
The "Hours" option increases and decreases in one-hour steps, while
the "Minutes" option increase and decreases in thirty-minute steps.
Press OK button to store.
NOTE: Not all suppliers provide this type of information
buttons you can increase (+) or decrease (-) the
55
"RSD - 7296" "RSD - 7296"