Code Download (Software) - Televes RSD - 7296 Instrucciones De Uso

User Manual
9.6.- Code upgrade (software)
Using this Menú you can upgrade the receiver's software directly from the
Internet using a PC.
You need to connect the receiver to a PC via an RS-232 cable and you
need to have the latest software version.
Press OK over the -Code upgrade- option. In the small window that
appears, you need to indicate if you wish to upgrade the software (YES)
or cancel the operation (NO).
If you press YES, the upgrading process will begin, and various progress
messages will appear onscreen.
After the receiver has been upgraded, it will begin to function.
Note: If you have only carried out an update of the channel list, you need to
execute the "Factory Default" option so that these become available.
If you would like to have the same software and the same channel list in
various receivers, you can duplicate this information (between the receivers)
if you dispose of a RS-232 cable (female - female).
On the MASTER receiver press the
ching the receiver on via the switch at the back of the equipment
(POWER). By doing this, the receiver has entered "Transmitir SW"
mode.
Configure the SLAVE receiver to receive the software. To do this, press
the & buttons at the same time as switching the receiver on via
the switch at the back of the equipment (POWER). By doing
this, the receiver has entered the "Actualizar SW" mode.
The duplicating process (copy) takes around 3 minutes and is over when
both receivers return to their normal operational mode.
The SLAVE receiver will finish the process a few seconds after the MAS-
TER receiver.
button at the same time as swit-
66
"RSD - 7296"