Diseqc 1.2 - Televes RSD - 7296 Instrucciones De Uso

User Manual User Manual
9.5.- DiSEqC 1.2 positioner
If in the -LNB number- option, you have selected "1", the Menú for the
DiSEqC 1.2 positioner will display the following options: "< DiSEqC 1.2
activated >", "< DiSEqC USALS >" and "< DiSEqC 1.2 de-activated >".
By pressing the OK button over each of the DiSEqC options, we can
access the area where we position the disk.
DiSEqC 1.2 activated
This Menú lets you change the dish's orientation so that you can select the
new orbital positions of the different satellites or correct the satellite posi-
tions that you have already saved.
- Satellite name. We should define the satellites that we are going to
use. To do so, use the
- Position. Each satellite has a different position number. There are 50
positions. Assign a position number to the satellite.
- Specify the transponder that you will use to check the received signal
level by using the
- Drive East / Drive West. You can move the dish to the East or West by
using the or
move the antenna just one step. If you keep the buttons pressed
down, the antenna will rotate smoothly. To save the position, press OK
over the "Store" option.
- Set East limit / Set West limit. These are the positions that limit the
orientation of the dish at each end of the arch.
This option will remain blocked as long as the "Limits Enable" option in
activated.
To set the limits after saving the orbital positions, select the limit that
you want to change (east or west) with the
Go to the "Drive East / Drive West" and with the
move the dish until you have reached the desired limit. Press OK over
the "Store" option to set it.
Return to the "Set East limit / Set West limit" option, select the other
limit and repeat the process.
- Store / Reset / Recalculate.
The "Store" option saves the limits and positions of each satellite if you
press the OK button over it.
The "Reset" option directs the antenna towards the South.
The "Recalculate" option orders the positions after adding new ones or
eliminating existing ones.
- Enable limits / Disable limits. This activates or de-activates the use of
the limits. If you do not use the limits, you run the risk of damaging the
motor elements or the dish.
or buttons.
or buttons.
buttons. If you press the buttons once, this will
or buttons.
or buttons,
64
"RSD - 7296" "RSD - 7296"