Connecting Headphones - Teac NR-7CD Manual Del Usuario

L
Skip (.//) buttons
During CD playback
Use to skip to the previous or next track .
Press and hold for at least one second during playback to
search forward/backward (page 22) .
During NET and Bluetooth playback
Use to skip to the previous or next track in the playlist .
M
Tray open/close (-) button
Press to open and close the disc tray .
N
VOLUME knob
Use to adjust the volume . Turn right to increase and left to
decrease the volume .
o Volume settings are saved separately for speaker and head-
phone outputs .
O
PHONES jack
Connect headphones (3 . 5 mm stereo mini plug) here .
o This headphone amp circuit uses a four-pole connector with
independent left and right for grounding . Ordinary plugs
with 3 or 4 poles can be used .
o If headphones are connected to this unit, audio will not be
output from the SPEAKER terminals on the rear panel .
NOTE
The following buttons on the unit and the remote control function
with CD, NET and Bluetooth playback .
Stop (8) button
Play/pause (7/9) button
Skip (.//) buttons
o This unit cannot be used to create playlists, for example, on
another unit connected to it . Playlists must be created and
other settings must be made to enable playback on connected
devices .

Connecting headphones

Wiring illustration
L+ R+
V
CAUTION
While wearing headphones, do not connect or dis-
connect them or turn the unit on or off.
Doing so could result in a sudden loud noise that
could harm your hearing.
Always set the volume to minimum (−∞ dB) before
putting headphones on.
L− R−
EN
15