Basic Operation - Teac NR-7CD Manual Del Usuario

Basic operation

1
Turn on the connected input source devices.
2
Shift the POWER switch to its ON position to
turn the unit on.
3
Turn the SOURCE knob to select an input
source.
18
The input sources will be shown in the following order
CD
NET
Bluetooth
OPT1
OPT2
COAX
LINE
o You can also use the input selection buttons on the remote
control .
o If the input signal is not a digital audio signal or is an audio
signal format that is not supported by this unit, such as
Dolby Digital or DTS, "NOT AUDIO!" will appear on the screen
and no audio will be output . Set the digital output of the
connected device to PCM audio output .
o To use NET or the USB port, install the dedicated app (page
6) on an iPad or other device, and connect it to the same
network as this unit (page 12) .
4
Start playback on the source device.
Refer to the operation manual of that device .
o CD and Bluetooth operation are explained in later sections
of this manual .