Display - Teac NR-7CD Manual Del Usuario

When the unit is turned on
WELCOME
TEAC
NR-7CD
After messages like the above appear, the input source will be
shown on the display .
Input source information
The input source information screen will appear after turning the
unit on as well as after about 10 seconds pass without operation on
a setting screen .
Display example
Input source name
OPT1
PCM 44k
Input signal status
o Turning the VOLUME knob will change the volume, and the vol-
ume will appear to the right of the input signal status .
Input source name
This shows the name of the selected source .
The names on the display correspond to the selected connectors as
follows .
CD
CD player in this unit
NET
ETHERNET port, USB port
COAX
RCA COAXIAL digital audio input connector
OPT1
Optical digital audio input connector 1
OPT2
Optical digital audio input connector 2
LINE
Analog audio input connectors
o When using Bluetooth, the name of the connected device is
shown .
c
51
- .5
Volume
Input signal status
This shows the input source signal status .
UNLOCK!
The unit cannot synchronize with the input signal .
NOT AUDIO!
A signal with a format that cannot be played is being received .
NETWORK!
The input source is NET, but the unit is not connected to a
network .
READY
The input source is NET and it is connected, but no audio signal
is being received .
WAV 44k
DSD 2.8M
DSD 5.6M
FLAC96k, etc.
These are abbreviations of the input signal type and sampling
frequency .
SBC
AAC
aptX
LDAC
When the input source is Bluetooth, abbreviations of the codec
type and sampling frequency are shown .
Volume display
The volume setting shown will be enlarged when you turn this
unit's VOLUME knob .
Display example
Volume -

Display

60
.0dB
EN
17