Sharp AN-SV100T Manual Del Usuario página 7

To Ensure Safe Operation
■
Make sure that the ceiling where the projector will be installed has suffi cient strength. If it does
not, reinforce it as necessary. When installing, use only the installation materials supplied with
the projector (specifi ed above). If the ceilling strength is insuffi cient or if the screw length is too
short, the installation may be insecure and lead to falling and even injury.
■
Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility
whatsoever if inadequate installation causes your projector or attached devices to fall out of place .
■
Do not hang on to the projector and do not hang or place heavy objects on the projector. This may
lead to injury or damage to the projector.
[About this manual]
This manual uses the installation of Sharp Projector XG-SV100W series. For questions
concerning the installation of products other than the XG-SV100W, please contact a
Sharp Authorized Projector Dealer or Service Center.
Install your projector in a location where it
will not be exposed to too much humidity
or dust.
Avoid installing your projector in an area with
excessive humidity, dust, oily fumes and
cigarette smoke. Doing so will soil the lens,
mirrors and other optical parts, and result in
blurring or dimming of the projected picture.
Do not let direct sunlight or other bright
light hit your projection screen.
If direct or bright external light falls on the
screen, the projected picture will become pale
and diffi cult to see. For rooms with incoming
light, always close the curtains.
Avoid using or storing your projector in
locations of high or low temperature.
Operating temperature range: 5°C to 35°C
Storage temperature range: -20°C to 60°C
Notes on installation
5