Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 104. Removing the status LED control panel for Front Accessed configuration
Next steps
Replace the status LED control panel for Front Accessed
Installing the status LED control panel for Front Accessed
configuration
Prerequisites
NOTE:
For Front Accessed configuration, the status LED control panel is on the rear of the system.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shrouds.
4.
Remove the processor heat sink
5.
Remove the expansion card riser
NOTE:
If required, remove the backplane power and signal cables.
Steps
1. Align and insert the status LED control panel assembly in the slot on the system.
2. Route the status LED control panel cable through the guide slots in the system and connector on system board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
3. Using the Phillips 1 screwdriver, tighten the screws that secure the status LED control panel assembly to the system.
NOTE:
Los números de la imagen no muestran los pasos exactos. Los números son solo para la representación de la
secuencia.
configuration.
Safety
instructions.
Before working inside your
module.
1.
system.
Instalación y extracción de componentes del sistema
105
Publicidad
Tabla de contenido
