Removing The Drive From The Drive Carrier - Dell EMC PowerEdge XR11 Manual Del Usuario

Ilustración 34. Instalación de un portaunidades
Siguientes pasos
Instale el bisel frontal, si se quitó.

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
1. Using a Phillips 1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the drive carrier has Torx screw , use Torx 6 (for 2.5-inch drive).
2. Lift the drive out of the drive carrier.
Instalación y extracción de componentes del sistema 45