Harbor Breeze MAYFIELD BTH44ABZC5C Manual Del Usuario página 11

FINAL INSTALLATION
4. Locate motor screws (M) and 5.4 mm lock
washers (N) previously removed (Step 5, page 7).
Insert two motor screws (M), along with 5.4 mm
lock washers (N), through one blade arm (J) to
attach blade arm (J) to motor. Tighten motor
screws (M) securely. Repeat with remaining blade
arms (J), making sure to completely secure each
blade arm (J) before proceeding with the next.
5. Remove three switch housing cap screws (V)
from top of light kit fitter (D).
If you wish to USE the light kit, remove finial (I),
finial plate (H), and rubber washer (Q) from
bottom of light kit fitter (D). Save hardware for
later use. Continue to Step 6.
If you do NOT wish to use the light kit,
proceed to Step 11, page 14.
6. Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT and remove
plastic that holds these two wires together. Also,
remove molex safety caps from bottom of BLUE
(or BLACK) and WHITE wires. It may be
necessary to pull firmly in order to remove
molex safety caps.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter (D). Connect
BLUE (or BLACK) wire from switch housing to
BLACK wire from light kit fitter (D). Make sure
that molex connections are secure.
4
5
V
Threaded
Rod
Q
6
Molex
Connections
Molex
Connections
Lowes.com/harborbreeze
11
J
J
N
M
V
D
H
I
Switch
Housing
Molex
Safety
Caps
D