Troubleshooting; Corrective Action - Harbor Breeze MAYFIELD BTH44ABZC5C Manual Del Usuario

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not
move.
Noisy operation.
Excessive
wobbling.
Fan operates but
light fails (if
applicable).
NOTE: A small amount of "wobble" is normal and should not be considered a defect.
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
1. Blades are loose.
2. Cracked blade.
3. Full range dimmer switch.
4. Fan is new.
5. Motor housing is loose.
1. Blades are loose.
2. Blade arms incorrectly attached.
3. Unbalanced blades.
4. Fan not securely mounted.
1. Bulb(s) not installed correctly.
2. Wires in outlet box not wired
properly.
3. Wall switch to fan is off.
4. Wires in switch housing not wired
correctly.

CORRECTIVE ACTION

1. Push switch firmly either up or
down.
2. Turn power on or check fuse.
3. Turn power off. Loosen motor
housing and check all connections.
1. Tighten all blade screws.
2. Replace blade.
3. Replace with an approved speed
control device.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High
speeds.
5. Turn power off. Carefully loosen
motor housing and verify that
mounting bracket is secure
according to instructions on page
10.
1. Tighten all blade screws.
2. Re-install blade arms.
3. Switch one blade with a blade
from the opposite side.
4. Turn power off. Carefully loosen
motor housing and verify that
mounting bracket is secure.
1. Re-install bulb(s).
2. Check wires in outlet box and, if
necessary, re-wire according to
instructions on pages 8 and 9.
3. Make sure that wall switch to fan
is on.
4. Check wires in switch housing
and, if necessary, re-wire
according to instructions on page
11.
Lowes.com/harborbreeze
17