Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
Locate rubber washer (Q), finial plate (H), and
9.
finial (I) that were previously removed (Step 5,
page 11). Place rubber washer (Q) inside glass
shade (E) over center hole. Align hole in center
of glass shade (E) with threaded rod on light kit
fitter (D), allowing pull chains to come through
corresponding holes in glass shade (E). Push up
gently on glass shade (E) until threaded rod
comes through hole. (Be sure fan pull chain does
not rub against bulbs during fan operation.)
Align hole in center of finial plate (H) with
threaded rod, allowing the pull chains to come
through appropriate holes in finial plate (H) and
push up. Thread center pull chain through hole in
finial (I) and secure glass shade (E) by tightening
finial (I).
NOTE: Do NOT overtighten finial (I) as glass
may crack or break.
Attach applicable pull chain extensions (F) or custom
10.
pull chain extensions (not included) to the fan and
light pull chains.
Assembly is now complete.
9
E
D
I
10
(For Fan)
Lowes.com/harborbreeze
13
Q
H
(For Light)
F
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
