Harman JBL MS-BassPro SQ Manual Del Usuario página 3

cOnnectIOns
IMportant: Disconnect the vehicle's negative (–) battery terminal
before beginning installation.
audIo sense sWItch:
No remote turn on connection is necessary because the MS-BassPro SQ
includes signal sensing turn on, which will turn the subwoofer on when
it receives an audio signal at its input connectors. The subwoofer will
automatically turn off approximately five minutes after the input signal
ceases.
If your audio system's source unit includes a remote turn on wire and you
would prefer to use it, defeat the signal sensing turn on circuit by moving
the Audio Sense switch to the "off" position.
connectIng the subWoofer to Your VehIcle's audIo
sYsteM
The JBL MS-BassPro SQ is equipped with two line-level (RCA) input
connectors that can handle line-level and speaker-level input signals. Use
RCA audio cables to connect the subwoofer to source units with preamp-
level outputs; use the supplied bare wire-to-RCA adapters to connect the
subwoofer to source units that don't have RCA output connectors. Consult
the following system application diagrams to help you plan the installation
of your MS-BassPro SQ. For additional installation suggestions, contact
your local authorized JBL car audio dealer.
If your car audio system's head unit has front or rear stereo line-
level outputs:
Use a stereo RCA audio cable (not supplied) to connect the MS-BassPro
SQ to the head unit's front or rear left and right line-level outputs.
L. Front
Speaker
L. Rear
Audio System
Speaker
Head Unit
Stereo RCA Audio Cable
(not supplied)
R. Front
Speaker
R. Rear
Speaker
Left/Right
Line-Level
Outputs
www.jbl.com
3