Included Items; Installing The Subwoofer - Harman JBL MS-BassPro SQ Manual Del Usuario

IntrOductIOn
Thank you for choosing the JBL
subwoofer. The MS-BassPro SQ has been designed to deliver outstanding
bass performance from a compact, easily installed powered subwoofer
enclosure.
To get the best performance from your MS-BassPro SQ, we strongly
recommend that installation be entrusted to a qualified professional.
Although these instructions explain how to install the MS-BassPro SQ in
a general sense, they do not show specific installation methods that may
be required for your particular vehicle. If you do not have the necessary
tools or experience, do not attempt the installation yourself. Instead,
please ask your authorized JBL car audio dealer about professional
installation.
In order that we may better serve you should you require warranty
service, please retain your original sales receipt and register your
MS-BassPro SQ online at www.jbl.com.

Included IteMs

MS-BassPro SQ
Powered Subwoofer
2
MS-BassPro SQ powered automotive
®
Bare Wire-to-RCA
Adapters (2)

InstallIng the suBwOOfer

InstallatIon WarnIngs and tIps
• Always wear protective eyewear when using tools.
• Disconnect the vehicle's negative (–) battery terminal before starting
the installation.
• Check clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel lines or
wiring harnesses, and that wire routing will not interfere with the safe
operation of the vehicle.
• When making electrical connections, make sure they are secure and
properly insulated.
• I f you must replace the MS-BassPro SQ's fuse, be sure to use the same
type of fuse and current rating as that of the original.
MountIng the subWoofer
Choose a location for the subwoofer that doesn't interfere with cargo,
a fold-down rear seat or the trunk lid. The best location is usually a
corner of the trunk or cargo area, as shown in the illustrations. These
locations, in addition to being out of the way, will provide the best sonic
reproduction in the 60Hz to 100Hz range because the woofer output
will be "corner loaded" against the vehicle's walls. In any case, the
MS-Basspro SQ must not interfere with the safe operation of the vehicle.