General Safety Tips - brennenstuhl SOL 80 Instrucciones De Empleo

Note: Make sure the correct poles are connected when connecting the battery. Incorrect
polarities can damage the device.

GENERAL SAFETY TIPS

1. Do not use any other solar module than the one provided. Using another solar module
can cause injuries or damage to the light and termination of the warranty.
2. Lay the cable such that it is secured and cannot create any kind of hazard (e.g. hazard
of tripping). Discontinue use of the solar light if the cable is damaged or defective.
CLEANING
Keep the motion detector free of dust and deposits by occasionally cleaning it with a dry
cloth or wiping it off with warm, soapy water. Also, make sure that the solar module is al-
ways free of dirt and deposits. A dirty solar cell cannot completely charge the battery.
This can cause premature aging in the battery and lead to unreliable function in the de-
vice.
STORAGE
Follow these steps if you are going to store you light for more than two or three days in-
side, in order to prevent damage to the battery:
1. Set the switch to the OFF-position.
2. Store the light and the solar module where the module can receive either sunlight or in-
door light every day. The battery needs light in order to retain its charge while stored.
3. During long-term storage, the unit must be completely recharged every four months. In
order to preserve complete and proper performance, do not store it for long periods.
NOTE THE FOLLOWING TROUBLESHOOTING SOLUTIONS:
1. Problem: Light does not activate when there is motion in the monitored area.
Possible Solutions: Make sure that:
- The switch is in the "AUTO" position.
- The LUX-selector dial is not set too far in toward ( ).
- The motion detector is set such that movements can be detected.
- The solar cell is aimed so that it can receive as much direct sunlight as possible during
the day.
- The battery's charge is not insufficient (charge for 3-4 sunny days with the switch set
to OFF).
2. Problem: Light comes on during the day.
Possible Solutions: Make sure that the LUX-selector dial is not set too far toward( ).
3. Problem: Light flickers.
Possible Solution:
- Weak battery. Charge the solar light for 3-4 sunny days, during which the switch must
be set to OFF.
10
Solar LED lamp SOL 80