Connecting The Iuxs - Minebea Intec IUXS4 Serie Instalación Y Advertencias De Seguridad

Connecting the IUXS... or IFXS...
Connecting Cable: IUXS.. or IFXS.. to Indicator
V + (Supply voltage +)
V – (Supply voltage –)
Signal + (Output signal +)
Signal – (Output signal –)
Sense + (Shield +)
Sense – (Shield –)
Ground (Shield)
8 Bedienungsanleitung IUXS4
Transporting the IFXS4...
(Option T7)
§ Remove the drive-on ramp from
the front of the scale.
§ Make sure there is no load on the
scale.
$ Make sure to observe the safety
instructions.
§ Remove the threaded caps from the
four threaded fasteners and save
them in a safe place.
$ Lubricate the threaded fasteners
regularly, so that the caps can
be removed and the hand cranks
attached at any time without
difficulty.
§ Attach the two hand cranks to the
two threaded fasteners at the front
of the scale.
§ Turn the cranks clockwise to lower
the transport rollers.
$ Repeat this procedure for the two
rear rollers.
Important:
Make sure there is no load on the
platform before you move it.
§ The scale can now be pushed
into the desired position
(rate of speed: < 1m/s).
Please observe the safety
instructions.
No.: EX
1
3
5
6
2
4
Cable: type A or
(white) or
(brown) or
(green) or
(yellow) or
(pink) or
(gray) or
§ If available, fasten the towing bar
(optional) as shown.
$ The scale can now be pulled
into the desired position (rate of
speed: <1 m/s).
Please observe the safety
instructions.
$ This procedure is useful, for
example, for cleaning the surface
beneath the scale at the place of
installation.
§ Return the weighing platform
to the place of installation and
retract the rollers.
§ Remove the hand crank.
§ Replace the four threaded caps.
§ Fasten the drive-on ramp to the
front of the scale.
$ Make sure to observe the safety
instructions.
Cable: type B
blue
black/brown
white
red/pink
green
gray