Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
2
size is 1.5 mm
. When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
DW203 - Selecting the operating mode (fig. B)
The percussion drill can be used in two operating
modes:
Rotary drilling:
for steel, wood and plastics.
Percussion drilling:
simultaneous rotating and impacting for
concrete and masonry drilling
operations.
15
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
• Select the required operating mode by rotating
the symbol on the mode selector (4) to the
required position.
Forward/reverse slider (fig. C)
• To select forward or reverse rotation, use the
forward/reverse-switch (3).
Replacing accessories
Inserting and removing a drill bit (fig. A)
60
Keyed chuck
• Open the chuck by turning the sleeve (6)
6
10
counterclockwise and insert the bit shank.
15
• Put the chuck key (7) into each hole in the side of
20
the chuck and turn clockwise until tight.
25
• To remove the bit, proceed in reverse order.
-
-
-
Keyless chuck (option)
6
6
• Open the chuck by turning the sleeve (6)
6
6
counterclockwise and insert the bit shank.
15
• Tighten firmly by turning the sleeve clockwise.
15
• To remove the bit, proceed in reverse order.
20
-
Placing and removing a screwdriver bit (fig. D)
• Hexagonal
be inserted directly into the chuck shaft.
• Remove the chuck as indicated under "Chuck
removal" and apply a strong pressure on the bit
to be inserted.
• To remove the screwdriver bit, hold the unit in
one hand and pull out the bit using nose pliers.
Chuck removal (fig. E & F)
Keyed chuck
• Open the chuck jaws as far as possible.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (8) by turning
clockwise as shown.
• Insert the chuck key (7) into one of the holes in
the side of the chuck and strike it with a hammer
as shown.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
1
/
" screwdriver bits and adapters can
4
E N G L I S H
en - 4
Publicidad
Capítulos
Tabla de contenido
