Assembly And Adjustment - DeWalt D25830 Manual De Instrucciones

E N G L I S H
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500
W, we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm 2 .
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm 2 )
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
22
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45
Cable rating (Amperes)
6 6 6 6
6 6 6 6 15
6 6 10 15 20
10 10 15 20 20
15 15 20 25 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25

Assembly and adjustment

Inserting and removing SDS-max
(fig. C1 & C2)
This machine uses SDS-max
inset in fig. C2 for a cross-section of an SDS-max
bit shank).
• Clean and grease the bit shank.
.
• Insert the bit shank into the tool holder (6), and
press and turn the bit slightly until the sleeve
snaps into position.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (6) and pull the bit out of the tool holder.
Indexing the chisel position (fig. D1 & D2)
The chisel can be indexed and locked into 8 different
positions.
• Press the safety lock (5) and rotate the mode
selector (4) until it points rearward. Release the
safety lock.
60
• Rotate the chisel in the desired position.
• Press the safety lock (5) and rotate the mode
6 10
selector (4) back to the forward position indicated
15
by the hammering symbol.
20
• Release the safety lock and check that the mode
25
selector switch is locked in place.
-
• Twist the chisel until it locks in position.
- -
6 6
Setting the electronic speed and impact control
6 6
dial (fig. B)
15
• Turn the dial (3) to the desired level. The higher
15
the number, the greater the speed and impact
20
energy. With dial settings from "1" (low) to "7" (full
-
power) the tool is extremely versatile and
adaptable for many different applications.
The required setting is a matter of experience.
Prior to assembly and adjustment always
unplug the tool.
®
chisels (refer to the
Only apply a slight amount of lubricant to
the bit shank. Do not apply lubricant to
the machine.
®
accessories
®