Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
230
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Inserting and removing SDS-max
(fig. C1 & C2)
This machine uses SDS-max
(refer to the inset in fig. C2 for a cross-section of an
®
SDS-max
• Clean and grease the bit shank.
.
• Insert the bit shank into the tool holder (8),
and press and turn the bit slightly until the sleeve
snaps into position.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (8) and pull the bit out of the tool holder.
Selecting the operating mode (fig. D1 & D2)
The tool can be used in two operating modes (fig. D1):
60
6
10
15
• To select the operating mode, rotate the mode
20
selector switch (7) until it points to the symbol of
25
the required mode.
-
-
-
0 - 2.0
6
6
6
6
6
6
10
10
10
15
15
15
20
20
20
Prior to assembly and adjustment always
unplug the tool.
®
drill bits and chisels
bit shank).
Only apply a slight amount of lubricant to
the bit shank. Do not apply lubricant to
the machine.
Hammer drilling: for concrete, brick,
stone and masonry drilling operations.
Hammering only: for chiselling and
demolition applications. In this mode the
tool can also be used as a lever to free a
jammed drill bit.
E N G L I S H
6
6
6
6
6
6
6
6
6
6
10
15
10
15
15
15
20
20
20
25
-
®
accessories
27
Publicidad
Tabla de contenido
