Assembly And Adjustment; Inserting And Removing The Battery; Selecting The Operating Mode - DeWalt DC212 Traducido De Las Instrucciones Originales

cable suitable for the power input of your charger
(see technical data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENT

WARNING:
• Prior to assembly and adjustment,
always remove the battery pack.
• Always switch off the tool before
inserting or removing the battery pack.
• Before using the tool, make sure the
battery pack is properly seated.
WARNING: Use only D
packs and chargers.

Inserting and Removing the Battery

Pack (fi g. A, B)
• Insert the battery pack into the grip until it clicks
in place.
• To remove the battery pack, press the two
release buttons (11) simultaneously and pull the
pack out of the grip.

Selecting the Operating Mode

(fi g. C1, C2)
DC212 (FIG. C1)
The tool can be used in the following operating
modes:
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Hammerdrilling: for concrete and
masonry drilling.
DC213 (FIG. C2)
The tool can be used in the following operating
modes:
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Hammerdrilling: for concrete and
masonry drilling.
Hammering only: for light chipping.
• To select the operating mode, press the safety
lock (4) and rotate the mode selector switch
(3) until it points to the symbol of the required
mode.
• Release the safety lock and check that the
mode selector switch is locked in place.
Inserting and Removing SDS Plus
Accessories (fi g. D)
Your rotary hammerdrill uses SDS Plus
accessories (refer to the inset in fi g. D for a cross-
section of an SDS Plus
• Clean and grease the bit shank.
• Insert the bit shank into the tool holder (5).
• Push the bit down and turn it slightly until it fits
into the slots.
WALT battery
• Pull on the bit to check if it is properly locked.
E
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the tool holder.
• To remove a bit pull back the tool holder locking
sleeve (5, 6) and pull out the bit.
Fitting the Side Handle (fi g. A)
The side handle (9) can be fi tted to suit both RH-
and LH-users.
• Loosen the side handle.
• For RH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
left.
• For LH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
• Rotate the side handle to the desired position
and tighten the handle.
Setting the Drilling Depth (fi g. E)
• Insert the required drill bit.
• Slacken the side handle (9).
• Fit the depth adjustment rod (8) through the
hole in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse Slider (fi g. F)
• Push the forward/reverse slider (2) to the
LH-side for forward (RH) rotation. See arrows on
tool.
WARNING: Do not select the operating
mode when the tool is running.
®
® bit shank).
WARNING: Always use the tool with
the side handle properly assembled.
EN G LI SH
®
39