Safety Summary; Component Names - Hitachi HARC-MODBUS Manual De Instalación Y Funcionamiento

HARC-MODBUS - Installation Manual
4 HARC-MODBUS - xxxxxxxxxxxxxxxxxx

1. Safety Summary

«
Caution:
Do not connect voltage input to the control system before
installation is correctly done.
Read this manual carefully before performing
installation work.
Read this manual in order to configure
the HARC-MODBUS.
¬
Attention:
Do not install HARC-MODBUS in places... :
– with vapour, oil or dispersed liquids.
– with heat sources nearby (sulphuric surroundings).
– where accumulation, generation or leaks of inflammable
gases has been detected.
– that are near the sea, in saline, acid or alkaline
surroundings.

2. Component names

The figure shows the names of the HARC-MODBUS components.
¬
Attention:
Install HARC-MODBUS away from possible sources
of electromagnetic waves.
Respect local electrical standards.
Use a power circuit that is not subject to peak demands.
Ensure that there is enough free space around
the HARC-MODBUS (see figure) so that the heat may
dissipate adequately (refer to "Installation Work").
If you install the HARC-MODBUS
in vertical position, install the power
supply in the lower part.
1 K1: H-LINK Connector:
2 K5: Serial port RS485
3 K3: +5V DC Power connection
4 Power source: 230V AC / 5V DC
5 H-LINK PCB
6 Packing glands (2)
7 7-segments
Connected to CSNET WEB
PMML0175A-rev.1 - 6/2008