Dash Disassembly; Kit Assembly - Metra 95-5817 Instrucciones De Instalación

Dash Disassembly

All Vehicles
1. Using the Metra 86-5618 removal keys, slide the
radio out of the radio cavity. Unplug and remove
the radio.
2. Cut and remove obstructions in dash cavity.
ATTENTION: Be careful not to cut into harnesses
or electronic components.
Continue to kit assembly
(Figure A)
Double DIN radio provision
1. Attach the double DIN brackets to the double DIN
using the screws supplied with the radio. (Figure A)
2. Locate the factory wiring harness in the dash. Metra
recommends using the proper mating adapter from
Metra or AXXESS. Re-connect the negative battery
terminal and test the unit for proper operation.
3. Reassemble dash in reverse order of disassembly.
4. Slide the double DIN radio unit assembly into the
modified sub dash until it clicks into place.
5. Clip the filler bar into the bottom of the radio opening
under the radio assembly with the rounded edges
facing toward the dash. Tip: Hook one side in then
push the other side in until it clips. (Figure B)
CAUTION:
Once the kit iS Snapped in, it
cannOt be remOved withOut
daSh panel remOval.
3

Kit Assembly

(Figure A)
(Figure B)