Tabla de contenido
Publicidad
EN
The following RS4 functions are not available when using the RSL 410/RSL
420 with the CU411-RS4 connection unit:
– Motion
– RS 232 configuration interface (RSL 410/RSL 420: communication via Ether-
net and Bluetooth)
Configuration
NOTICE
Only use configuration for RSL 410/RSL 420 with CU411-RS4 connec-
tion unit!
Configurations for RSL 410/RSL 420 with CU411-RS4 connection unit
may not be used for scanner units with other connection units.
Ä
The RSL 410/RSL 420 is configured for the respective scanner unit independent
of the CU411-RS4 connection unit.
– The Sensor Studio configuration and diagnostics software does not monitor
configuration restrictions which are caused by the CU411-RS4 connection
unit.
– Configured functions, in which attention has not been paid to the restric-
tions , that are caused by the CU411-RS4 connection unit, are not available
for propagation time. Thus, the switching on of the OSSDs is prevented or
error messages are issued.
NOTICE
Check the function of the safety sensor before commissioning!
Check the function of the safety sensor before commissioning (see
Original operating instructions of the RSL 410/RSL 420, chapter 11
"Check").
Electrical connection
The data about electrical supply of the RSL 410/RSL 420 applies to the voltage
supply and all switching inputs/outputs (see Original operating instructions of the
RSL 410/RSL 420, chapter 15 "Technical data").
NOTICE
Ä
Ä
10
Only use configurations for RSL 410/RSL 420 with CU411-RS4
connection unit for scanner units with CU411-RS4 connection unit.
Make sure that the control voltage of the signal inputs corresponds
to the information on the RSL 410/RSL 420.
Make sure that the voltage supply is suitable for the RSL 410/
RSL 420.
Publicidad
Tabla de contenido
