Sanus VLF220 Manual De Instrucciones página 7

2
Mount the Wall Plate
Wood stud mounting
2-1
Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[17]
[16]
6901-002111 05
≤ 16 mm
(5/8 in.)
[02]
[02]
[02]
Locate studs. Verify the center of the stud(s) using an awl. a thin nail,
or an edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Drywall covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
(nominal 38 x 89 mm (1.5 x 3.5 in.))
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [02] and mark the hole locations. NOTE: TV
will shift 82.5 mm (3.5 in.) to the right when in the home position.
Consider this when selecting the location of your wall mount.
Drill pilot holes as illustrated.
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [17].
Tighten the lag bolts only until the washers [16] are pulled
fi rmly against the wall plate [02].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
82.5 mm
3.25 in.
89 mm
(3.5 in.)
[01]
7