Braun Easypump ST Manual De Instrucciones página 4

STORAGE:
Your Easypump ST/LT devices should be stored:
CAUTION:
The Easypump ST/LT device must be allowed to reach room temperature prior to use.
If the solution is colder than room temperature, the infusion time will likely be longer than anticipated.
Failure to allow solution to reach room temperature can lead to longer infusion time. It should be near room
temperature when you use it. Simply remove each dose from the refrigerator 6-12 hours before you plan to
infuse. (If frozen, remove from the freezer 12-18 hours before use.) It is a good idea to remove the next dose
from the refrigerator or freezer during the time of the current infusion. If the time between infusions is less
than 6 or 8 hours, then removing two doses from the refrigerator or freezer at one time is suggested.
WARNING:
DO NOT HEAT
any other heat source. Heating may cause problems with the device and flow rate.
PREPARING FOR THE INFUSION
the Easypump ST/LT device in a microwave oven, direct sunlight, hot water or
► Wash your hands thoroughly, as instructed by your healthcare provider.
► Check the drug label on your Easypump ST/LT device. Be sure that your
name, the medication name and the dosage are correct. Be sure that
the expiration date has not passed.
► Be sure that the clamp on the tubing is in the closed position.
In the refrigerator
In the freezer
Other