ratiotec Smart Protect Manual De Instrucciones página 11

Software Update
Software Update Smart Protect with microSD card
1.
Insert the microSD card into the microSD card slot at the back of the detector.
2. Hold the ON/OFF key until the LED turns yellow.
3. The software is automatically implemented on the device.
4. After successful updating, the detector will beep two times and will switch off automatically.
Software Update Smart Protect Plus with microSD card
1. Insert the microSD card into the microSD card slot at the back of the detector.
2. Hold all three buttons until "UPD" is shown on the display.
3. The software is automatically implemented on the device.
4. After successful updating, the detector will beep two times and will switch off automatically.
Note: An update via an update cable is also possible. When you do this, please use the Update Manager, which
you can easily download from the following link https://ratio-tec.com/download. For all further steps, please
refer to the Update Manager.
Technical Settings
Detection Feature
Speed
Operating Temperature
Humidity
Storage Temperature
Battery
Power Supply
Power Consumption
Dimensions (l x d x h in mm)
Weight (in kg)
External Interface
MG, IR, SD, MT, Colour
0,5 seconds
0~40 °C
40~90 %
-25~55 °C
Rechargeable lithium battery 10.8V/600mA
AC100V~240V 50/60Hz or DC12V/1.0A
< 10 W
137 x 117 x 62
0.5
USB port | SD card slot
[ EN]
11