General Safety Instructions - Bosch T40137 Instrucciones Originales

en-gb | 8 | T40137

2 General Safety Instructions

WARNING
Read and follow all safety notes and instructions!
Failure to follow the safety instructions may result in
serious injuries and material damages.
Observe and follow the safety notes below.
The load holding device has been specifically
constructed for its intended use. The safety of the
load holding device can no longer be ensured if it is
misused or modified in ways not expressly approved
by the manufacturer. Serious injuries or damage to
property can occur.
Ensure that each person using the load holding
device is familiar with these instructions and can
access them at all times.
Ensure that all users are also familiar with the
operating manuals of all tools and workshop
equipment, which are necessary for the work.
Carefully read and adhere to the instructions in the
technical safety information of the Volkswagen
Group brands.
Wear safety shoes (according to ISO 20345, S2).
Wear protective gloves in order to avoid cuts.
Position hands and feet carefully to avoid potential
crushing hazards.
Use the load holding device only for work approved
by the Volkswagen Group.
Use the load holding device only with the
accessories approved by the Volkswagen Group.
2018-07-02
Do not exceed the maximum load capacity of
180 kg. Complete turning in of both screws is
necessary. The support must be suspended
vertically on the crane. Transverse and diagonal
forces are not permitted (see Figure).
Tighten the screw connections with the prescribed
torque (see workshop manuals of the Volkswagen
Group brands).
Ensure that the track for the workshop crane
e.g. VAS 6100 is clear and easily visible.
Move the load slowly and carefully.
Observe the support and the load during all
movements.
The positioning of persons under the load and in the
dangerous area is prohibited during the movement
process.
Do not work on suspended loads.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany