Bosch GBH18V-20 Instrucciones De Funcionamiento Y Seguridad página 12

2610048709.qxp_GBH18V-20 6/19/17 12:41 PM Page 12
"VARIO-LOCK"
Choose a position which is best suited for
your operation. The Vario-Lock position is
intended for use with chipping bits such as bull
points, spades, gouges, etc. Depress release
button and turn the selector dial, to the
"vario-lock" setting. Next, rotate the locking
sleeve, along with the accessory, to the
desired position. Then turn the selector dial
to the "hammer only" setting and slightly turn
the locking sleeve to have it automatically
lock into a definite position (Fig. 11).
SLIP CLUTCH
The tool has a internal pre-set slip clutch. The
output spindle will stop rotating if the accessory
binds and overloads the tool.
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 12).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
1
BATTERY PACK
RELEASE BUTTON
INSERTING AND RELEASING BATTERY PACK
FIG. 12
BATTERY PACK
2
2
SELECTOR
DIAL RELEASE
BUTTON
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 12).
-12-
FIG. 11
1