Maintenance And Cleaning; Declaration Of Conformity - Würth master EB 13-2 Manual Original

EB 20.book Seite 9 Montag, 16. Februar 2009 2:17 14
Operating instructions
The material to be cut must always be free of oil or
grease.
Always place the machine flat on the workpiece.
Cut-outs: Drill a starting hole with a 12 – 14 mm
diameter drill.
Circular cuts: Always cut counter clockwise and
from left to right.

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
If the machine should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorized customer service agent
for Würth power tools.
For all correspondence and spare parts orders,
always include the article number on the type plate
of the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
Warranty
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth compressed-air and power tools.
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
corporation into national law, power tools that are
no longer suitable for use must be separately collect-
ed and sent for recovery in an environmental-friend-
ly manner.

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
DIN EN ISO
EN 50 144,
DIN VDE 0740-21 according to the provisions of
the regulations
98/37/EG, 93/68/EWG, 04/108/EG.
08
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Disposal
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its in-
12100-1, DIN EN ISO 12100-2,
EN 55 014, EN 60 555,
A. Kräutle
9