Recommendations For Optimal Han- Dling Of The Battery; Maintenance And Cleaning - Würth master 0700 624 Serie Manual Del Usuario

All manuals and user guides at all-guides.com
OBJ_BUCH-1468-001.book Page 18 Wednesday, July 20, 2011 11:10 AM
Tips
Before screwing larger, longer screws into hard mate-
rials, it is advisable to predrill a pilot hole with the core
diameter of the thread to approx.
length.
Belt Clip
With the belt clip 4, the machine can be hung onto a
belt. The user has both hands free and the machine is
always at hand.
Recommendations for Optimal Han-
dling of the Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between 0 °C and 50 °C. As an example, do not
leave the battery in the car in summer.
Occasionally clean the venting slots of the battery
using a soft, clean and dry brush.
A significantly reduced working period after charging
indicates that the battery is used and must be
replaced.
Observe the notes for disposal.

Maintenance and Cleaning

❏ Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off switch
can lead to injuries.
❏ For safe and proper working, always keep
the machine and ventilation slots clean.
Replacing the Carbon Brushes
(see figure C)
Check the length of the carbon brushes approx. every
2–3 months and replace the carbon brushes if
required.
Never replace only a single carbon brush!
Note: Use only carbon brushes supplied by Würth
and intended specifically for your product.
• Unscrew the caps 15 using a suitable screwdriver.
• Replace the spring-loaded carbon brushes 14 and
screw the caps back on again.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
2
/ of the screw
3
viewed in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.
For this Würth power tool, we provide a guarantee in
accordance with the legal/country-specific regula-
tions from the date of purchase (verified by invoice or
delivery document). Damage that has occurred will
be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your Würth
sales representative or a customer service agent for
Würth power tools.
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special requirements
on packaging and labelling must be observed. For
preparation of the item being shipped, consulting an
expert for hazardous material is required.
Dispatch batteries only when the housing is undam-
aged. Tape or mask off open contacts and pack up
the battery in such a manner that it cannot move
around in the packaging.
Please also observe possibly more detailed national
regulations.
Guarantee
Transport
18