Vacuum Cleaner Assembly - ARIETE 2752/1 Manual De Instrucciones

EN
19. Make sure that the power cord does not come into contact with sharp or hot surfaces.
20. Never use the appliance if the power cord is damaged.
21. If the cord is damaged, it must be replaced by the Manufacturer, by an Autho-
rised Technical Assistance Centre or in any case, by a similarly qualified person,
in order to prevent any risks.
22. Always switch on the appliance with the power regulator set to minimum.
23. Unplug the appliance from the mains electricity after each use.
24. In the event that you decide to dispose of the appliance, we advise you to make
it inoperative by cutting off the power cord. We also recommend that any parts
that could be dangerous be rendered harmless, especially for children, who may
play with the appliance or its parts.
25. Packaging must never be left within the reach of children since it is potentially
dangerous.
26. To dispose of product correctly according to European Directive 2012/19/
EU, please refer to and read the provided leaflet enclosed with the product.
DO NOT THROW AWAY
THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (FIg.1)
A Lever to open the dust bag compartment
B Suction device coupling
C Bag full indicator
D Cord re-wind switch
E Suction power regulation dial
F On/Off switch
G Attachment compartment
H Dust bag compartment
I Fabric bag
L Carry handle
M Paper bag

VACUUM CLEANER ASSEMBLY

Insert the hose into the suction opening, pressing it down until it slots into place. To remove the hose,
press the two release buttons together and pull it out (FIG. 2).
CAUTION: Before fitting or removing attachments, always be sure to unplug the appliance from the
mains power.
N Parquet brush
O Round nozzle with brush
P Crevice nozzle with brush
Q Release buttons
R Hard floor / carpet selector
S Brush for floor / carpets
T Handle
U Suction control
V Sliding device
Z Telescopic tube
X Flexible hose
- 8 -