Harman Infinity BassLink DC Guia De Inicio Rapido página 3

Thank you for choosing the Infinity BassLink DC. To ensure maximum
performance, we strongly recommend that you have it installed by a
qualified professional – while these instructions offer general installation
guidance, they do not show specific installation methods for your
particular vehicle. If you do not have the necessary tools or hands-on
experience, do not attempt the installation yourself; instead, ask your
authorized Infinity car-audio dealer about professional installation options.
Please refer to your owner's manaul (available at infinityspeakers.com) for
more detailed instructions. (http://www.infinityspeakers.com)
x1
INSTALLATION
IMPORTANT: Disconnect the vehicle's negative (–) battery terminal
before beginning the installation.
• Always wear protective eyewear when using tools.
• Check clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel lines, or
wiring harnesses, and that wire routing will not interfere with the safe
vehicle operation.
• When making electrical connections, make sure they are secure and
properly insulated.
• If you must replace the fuse, be sure to use the same type of fuse and
current rating as that of the original.
• Drill pilot holes in the mounting surface.
• Attach the BassLink DC to the mounting surface with four appropriate
mounting screws.
NOTE: You may find it more convenient to make all of the connections to
the amplifier before you permanently mount it
Choosing a Mounting Location
Choose a location that doesn't prevent you from loading or unloading
cargo, interfere with fold-down seats, or keep you from being able to open
or close the trunk lid, or interfere with the safe operation of the vehicle.
POWER
PROTECT
GAIN
MIN • • MAX
BASS EQ
FLAT • • + 9 dB
CROSSOVER
50 Hz • • 120 Hz
x4
x1
x1
x1
BassLink DC
Mounting the BassLink DC
Choose a location that doesn't prevent you from loading or unloading
cargo, and doesn't interfere with normal vehicle operation. Then, secure
the mounting bracket using four sheet metal screws in the slots at each of
its four corners. It may be more convenient to mount the bracket without
the BassLink in place, once you have test-fitted the assembly.
To attach the bracket to the BassLink DC, slide the rear arm of the
bracket into the bottom rear slot of the BassLink DC, and allow the
BassLink DC to rest on the bracket. To secure the spring-loaded front
arm of the bracket, turn the knob clockwise until the front arm slides into
the front slot of the BassLink DC.
Rotate clockwise to tighten
BassLink DC wiring harness
POWER/HI-LEVEL IN
NOTE: to access the power and signal inputs on the BassLink DC, simply
remove the cover on the side panel by pulling. Once all connections are
made, replace the cover.
The included wiring harness features power, ground, remote signal, and
speaker-level input wires.
Wiring harness: power, ground,
remote, and speaker-level
connections
EN