Mowing; Working Instructions; General Working Instructions; Setting The Cutting Height - Deltafox DG-PLM 4019 P Traducción Del Manual De Instrucciones Original

GB
Cold start:
1. Press the petrol pump
(30)(primer) 3 x.
2. Pull the safety loop (2) towards
the grip handle (1) and hold it.
3. Pull the starter handle (7).
4. If the motor starts slowly, re-
lease the starter handle into the
starter rope-guide (3).
For a warm start it is not neces-
sary to press the primer (30).
If the primer is pressed too often,
too much petrol will enter the car-
burettor and the motor is difficult to
start.
Motor stop:
• Release the safety loop (2). The motor
switches off and the knife is braked.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (2). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.

Mowing

1. Start the engine (see
2. Hold the grip handle (1) and the safety
loop (2) with both hands while mow-
ing.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
84
• Run the equipment at walking speed
• Do not move backwards.
• On slopes, always work across the
• If the blade comes into contact with
• Switch off the equipment during longer
• Clean the equipment after each use,
The equipment has 3 positions for setting
the cutting height (25/45/65 mm):
1. Unscrew the wheels (15/17).
2. Screw the wheels (15/17) back into
).
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Cleaning and
Maintenance
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
slope.
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
breaks and for transportation and wait
until the blade is stationary.
as described in the "cleaning and
maintenance" chapter.
Setting the Cutting
Height
the desired place. All wheels must be
set to the same height.
Select a greater cutting height for
the first cut of the season.
Have any repair and mainte-
nance work not described in