Worx WG119E Traducción De Las Instrucciones Originales página 11

5. Recommendation
The machine should be
supplied via a residual
current device (rcd) with a
tripping current of not more
than 30mA.
SYMBOLS
Read operator's manual
Keep bystanders away
Wear eye and ear protection
Do not expose to rain
Disconnect the mains plug if
the cord becomes damaged or
entangled.
Double insulation
Waste electrical products
must not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your local authorities or retailer
for recycling advice.
Edging
2-in-1 Grass Trimmer/Edger
Trimming
Unlock
Wear protective gloves
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for the cutting of grass and
weeds under bushes, as well as on slopes and edges
that cannot be reached with the lawn mower.
WARNING! To avoid injury from unexpected
starting or electrical shock during assembly or
adjustment, do not plug the power cord into a source
of power.
Action
Assembly
Assembling Safety Guard
WARNING: Make Sure the
Safety Switch is Locked
Off to Prevent Accidental
Starting.
Assembling auxiliary handle
Pigtail power cord
Operation
ON/OFF Switch
WARNING! The cutting head
continues to rotate after the
trimmer has been switched off;
wait until it has completely
stopped then lay down the tool.
Trimming
Adjusting the Height
Adjusting the Auxiliary Handle
Adjusting the Trimmer Head
Trimming
Using the Flower Guard
Figure
11
See Fig. A, B
See Fig. C
See Fig. D1,D2
See Fig. E
See Fig. F1
See Fig. F2
See Fig. F3
See Fig. F4
See Fig. F5, F6
EN