Yamaha Z250D Manual Del Propietário página 182

4-22
EMU01560
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise
the lower case and propeller boss may
be damaged.
8 Be sure to use a new cotter pin and
bend
Otherwise, the propeller could come
off during operation and be lost.
1) Apply
Corrosion resistant grease to the pro-
peller shaft.
2) Install the thrust washer and propeller
on the propeller shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut further
602053
to align it with the hole.
the ends over
Yamaha Marine
E
securely.
grease or