Bestway HYDRIUM 56377 El Manual Del Propietario página 9

7. If it rains, check that the water level is not higher than the specified level.
If water exceeds the specified levels, drain the pool to the specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
ATTENTION: Please do not clean or perform any maintenance work on the PVC
liner when the temperature is lower than 5°C (41°F).
The following parameters ensure good quality water
Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
WINTERIZATION
If you do not want to dismantle the pool in winter, please observe the following
instructions:
IMPORTANT: Do not drain all of the pool water. If you do so, the pool may be
damaged by strong wind. Drain the water to 10cm below the inlet valve on the pool
wall.
1. Drain the water to 10cm below the inlet valve on the pool wall. You can use a
pump or a garden hose (Diagrams 19, 20).
2. Treat the pool water with a suitable chemical product.
3. Remove the filtration system from the pool.
You can leave the inlets/outlets attached to the pool.
4. Also remove any other pool accessories and store them in a dry and cool place.
5. Protect the pool with the pool cover.
If you want to dismantle the pool in winter, please observe the following instructions:
1. Drain the pool with a garden hose, or use a drain pump to empty the pool
(Diagram 19).
2. Clean all pool parts with a sponge and soap with a neutral pH. Dry them and tidy
them away in a dry and clean place.
19
20
10cm
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max. 100
max. 0,5 (preferably close to 0,0 mg/l)
RE- ASSEMBLY
Carefully inspect your pool to ensure that there are no missing or damaged parts.
1. Follow steps 1 through 8 for assembling the rail and steel wall.
2. Align the holes on both the steel wall and the liner.
3. Assemble the control valve and strainer.
#04
#08
4. Follow steps 9 through 13 and fill the pool with water.
NOTE: If you discover the liner is damaged, please contact our After Sales Service or
purchase a new liner.
9
S-S-004186