DeWalt DW7460 Manual De Instrucciones página 5

Hardware Included with the DW7460
Mobile Base
BOLT
CARRIAGE BOLT
8 MM X 60
8 MM X 20
(2 PIECES)
(8 PIECES)
CARRIAGE BOLT
8 MM X 40
(4 PIECES)
CARRIAGE BOLT
8 MM X 60
(2 PIECES)
FLAT WASHER
28 MM OD
(4 PIECES)
Items Included
• (2) End Bracket
• (2) Side Support
• (1) Castor sub-assembly
• (2) Wheel
• (2) Wheel Housing
• (1) Extension Lever
• (1) Hardware bag
Tools needed
• (2) 13mm or 1/2" open end wrench or socket wrench
• (1) Standard Pliers
Necessary Hardware
Your hardware bag contains all the necessary nuts, bolts,
and washers to assemble the components included with
the DW7460 Mobile Base and to attach it to the DW746
Woodworker's Table Saw. To make assembly of your
mobile base easier, match the nuts, bolts, and washers
with the hardware chart. Before each step, check your
hardware against the chart and identify the pieces you
need.
NUT HEX
(18 PIECES)
Assembly
PLEASE READ ENTIRE ASSEMBLY SECTION
NUT SELF-LOCKING
STEP 1. Unpack parts and lay out per Figure 1.
(2 PIECES)
FIG. 1
LOCK WASHER
(14 PIECES)
FLAT WASHER
(2 PIECES)
RETAINING RING
(2 PIECES)
BEFORE PROCEEDING.
STEP 2. Assemble side supports to an end bracket
(Fig. 2).
You will need: 4 - 8 x 20mm carriage bolts
4 - 8mm lock washers
4 - 8mm nuts
Add carriage bolts from the inside and secure each
FIG. 2
STEP 3. Assemble wheel housings and remaining end
bracket (Fig. 3).
You will need: 4 - 8 x 20mm carriage bolts
4 - 8mm lock washers
4 - 8mm nuts
Align wheel housings and remaining end bracket to the
side rails. Add carriage bolts from the inside and secure
each with a lock washer and nut. Finger tighten.
FIG. 3
STEP 4. Lay base on flat surface to insure assembly is
square and level. Securely tighten all hardware.